Welcome to the Gerzy Bear Performance Jseries Billet Aluminum Intake Manifold System!
About our product:
We are excited to offer this intake manifold & fuel rail system after a decade of experience and development of version 1 back in 2013. This project has evolved from a hand made manifold into a CNC machined, light weight, and performance engineered billet aluminum masterpiece!
Designed to be the ultimate in performance minded replacements available for your Jseries induction systems, our intake manifold system is compatible with most Honda/Acura Jseries V6 engine models as listed. It maximizes air delivery to your cylinder heads regardless if your vehicle will remain Naturally Aspirated, or adopt a Supercharger kit, run nitrous oxide, etc. It also weighs less than any other OEM intake manifold and runner pairing in existance!
Photos of the manifold on this webpage as of the pre-order are for illustration purposes only, as they are 3D Printed prototypes and our final product is Billet Aluminum which will have a few changes such as the addition of water/meth/nitrous injection ports as well as reshaped throttle body flanges.
Standard Parts List:
-Gerzy Bear Performance Full Billet Aluminum Upper Intake Manifold with Dual Plenums (CNC Machined Finish - No Coating Available)
-Gerzy Bear Performance Full Billet Aluminum Lower Intake Runners (CNC Machined Finished - No Coating Available)
-Gerzy Bear Performance Billet Fuel Rails (required) using 6AN ORB ports (Black Anodized)
-Required Stainless Steel Fastener/Bolt hardware
-Required Orings for sealing mating surfaces
Optional Parts:
Custom Modified Dual Throttle Bodies with Linkage Shaft and Brass Bushings & OEM Style Throttle Body Gaskets.
Intake piping for 2004-2008 Acura TL and 2003-2007 Hinda Accord.
6an Fuel Line Adaptation kit for otherwise stock fuel systems.
Other Important Guidelines:
- Our bespoke Billet Upper Intake Manifold with Dual Plenums, Billet Aluminum Lower Intake Runners, as well as Billet Aluminum Anodized Fuel Rails are all mandatory parts for function of the system as designed. If you wish to supply your own drive by cable throttle bodies, you may - but we do not provide throttle body adapters, throttle body cables, or cable brackets. We recommend visiting P2R Power Rev Racing for throttle body adapters for such cases.
-You are responsible for connecting the upper intake manifold to your intake piping or forced induction piping. We do not currently offer a pre-made solution.
- We do not make claims of expected horsepower gains. Our overall design is targeted as best-in-market regardless of your intended use! In other words, This is not just an everyday upgraded ported and polished oem or otherwise cast intake manifold and lower runner swap.
- Once installed, our intake manifold system achieves nearly the same peak height as a 2007-2008 Acura TL-S intake manifold and yet is 3 inches shorted in length, and 1 inch narrower in width! See photos
- We use o-rings on mating surfaces for a high quality seal.
- We include all fastener hardware, orings and throttle body gaskets aside from what should be swapped over from your existing engine such as MAP sensor & IAT sensor.
Before adding this item to your shopping cart, you will be prompted to select the necessary product option and disclaimer.
Thank you!
